This is a demo store. No orders will be fulfilled.

This is a demo store. No orders will be fulfilled. The price shown here is not the real/final price. Please contact customer service by click on the dialog box in the lower left corner if you want to place an order, or visit www.foxtechfpv.com to shop online.

foxtech drone store

Contact us

for any questions

PWM Output Liquid Level Senser

In stock(4)
Sku:  710261
Weight:  50g
$31.90
Reward Points With this product, you earn 32 loyalty points.
Liquid level sensor is used to measure the level of the free-flowing substances. Such substances include water, oil, gasoline, diesel, agricultural chemicals, etc. These substances tend to get settled in the container tanks due to gravity and maintain their level in rest state. Level sensors measure their level against a pre-set reference.

Liquid level sensor is used to measure the level of the free-flowing substances. Such substances include water, oil, gasoline, diesel, agricultural chemicals, etc. These substances tend to get settled in the container tanks due to gravity and maintain their level in rest state. Level sensors measure their level against a pre-set reference.


Specification:

Weight: 31g
Power supply: DC 3~6V
Dimension: 60x35x25mm
Range: 30 cm water or other liquid comparable
Output: 5V 50 Hz PWM, 0%-1100us 100%-1900us
Precision: 5%
Calibration: Yes
Service Temperature: -20 ~ 40 °C

Your Purchase Includes:
1x Liquid Level Senser
1x A(yellow) hose
1x B(green) hose
1x PWM signal cable


Installation

a. We recommend to install sensor above the liquid container. A/B hoses go into the container through the top of the container.
b. A hose goes into container from top. Keep hose end above the liquid and in the container.
c. B hose goes into container from the top. Make sure its end lies on the bottom of liquid container.

Calibration

a. The green status light is on when power supplied.
b. Calibrate 0% empty level: when container is empty, press calibration button 5 seconds, status light begin to blink. 0% liquid level is calibrated.
c. Calibrate 100% full level: Fill the container full with liquid. Press calibration button 5 seconds, status light stops blinking. 100% liquid level is calibrated.
d. Calibrate again when container is changed or the sensor does not work properly.

Operation
a. Connect PWM output port to UAV flight control or Data Acquisition Module.
b. Power on. The green status light is on. The sensor works.

 

 

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account